Data Status
Common Fleet Module
One entrant list is shared by Championship, Pointscore, Sprints and PointsHCP. A registered entrant is therefore present in every series and defaults to DNC when not racing.
Season Setup
Set the club and season. Existing race data and results are retained.
Series Setup
Series Name is the visible seasonal name. Scoring Type determines how race places are calculated. Website Slot is the stable Results-page destination and does not change with the seasonal name.
Workflow
Common Fleet Entrants
This single entrant list applies to Championship, Pointscore, Sprints and PointsHCP. Add or edit an entrant once here; every series uses the same record.
Current Entrants is hot: this is the current Common Entrant count used by the seasonal DNC = Entrants + 1 rule. Adding or removing an entrant changes this value and immediately updates DNC scores in completed and future races, unless a fixed Custom DNC override is active.
Delete: removes the entrant from every series and race. If they have race results, those results are removed too and every affected race is recalculated. Not permanent until you SAVE DATA.
Race Entry
Every new race starts with DNC for every entrant. Enter Start + Finish, enter/edit Elapsed Raw directly as h:mm:ss, or replace DNC with another result code. A code may be used instead: DNC, DNS, DNF, RAF, RET, DSQ, OCS, BFD, DNE, DGM, UFD, NSC, DUT.
PointsHCP — Next Race Setup — HCP / Advantage
Until a boat has finished a PointsHCP race, its HCP comes from its Yardstick (HCP = Yardstick ÷ Reference Yardstick). The fastest boat is scratch (0 min); each slower boat's Advantage = race duration × (its HCP − scratch HCP), in whole minutes. Staggered start (Min Adv ticked): each boat starts at the race Start Time minus its Advantage, Elapsed = finish − race Start Time, and places follow the finishing order. Sail Time = Elapsed + Advantage is used to recalculate HCP, independent of the Advantage.
Scoring rules Warning: Changing these rules will be applied to all past races. It is a Seasonal Change for ALL Series and ALL Races.
Shared by Championship, Pointscore, Sprints and PointsHCP. Entrants is everyone currently in the entrant table. Starters is an entrant with an elapsed time, or any code except DNC and DUT (so DNS, OCS, DNF etc. all count as starters). Finishers is an entrant with an elapsed time only. Click a base to select it; the offset is added to that base.
| CODE(S) | BASE (CLICK TO SELECT) | OFFSET | Custom DNC |
|---|---|---|---|
| DNC | + | ||
| DNS, OCS | + | ||
| DNF, RAF, RET, DSQ | + |
Hot seasonal rules: DNC defaults to Entrants + 1. Entrants is the current Common Entrant count, so adding an entrant immediately changes DNC in completed and future races. Any applied rule change recalculates completed races and Series Results. A Custom DNC fixed value overrides Entrants + 1 for every race.
Custom DNC: leave blank to use the selected DNC base + offset. Enter a number to override the formula and use that fixed DNC score in every race.
Fixed recognised codes: BFD = Starters +1; DNE = Starters +1; DGM = Starters +1; UFD = Starters +1; NSC = Starters +1. DUT is hot: it is the average of the best genuine finishes from all races in the series, earlier or later (up to the configured number), so every DUT for an entrant updates when a new finish is added. If fewer exist, all available finishes are averaged; the decimal average is retained.
Race Officer View
This is the amendment/review stage. Edit any race-result cell; the entire race recalculates hot. Confirm or cancel before committing.